Activation all brands cars for EasyDiag, Golo Easydiag+, iDiag, Golo M-Diag on Android

RESETBLEED - The software is use for ABS bleeding. When the ABS contains air, the ABS bleeding function must be performed to bleed the brake system to restore ABS brake sensitivity..

RESETDPF - The software is used for Regeneration of diesel particulate filter. DPF regeneration is used to regularly clear PM (particulate matter) from the trap in combustion oxidation mode (such as high temperature heating combustion, fuel additive or catalyst reduce PM fire point combustion) to stabilize trap performance.

RESETGEAR - The software is use for gear learn. Crankshaft position sensor adaptive learning. The crankshaft position sensor learns crankshaft tooth machining tolerance and save to the computer to more accurately diagnose engine misfires. If tooth learning is not performed for a car equipped with Delphi engine, the MIL turns on after the engine is started.

RESETTPMS - The software is use for Tire pressure sensor reset. After the tire pressure MIL turns on and maintenance is performed, the tire pressure resetting function must be performed to reset tire pressure and turn off the tire pressure MIL.

RESETSAS - The software is use for SAS reset. To reset the steering angle, first find the relative zero point position for the car to drive in straight line. Taking this position as reference, the ECU can calculate the accurate angle for left and right steering.

RESETIMMO - The software is use for Immobilizer. To prevent the car being used by unauthorized keys, the anti-theft key matching function must be performed so that the immobilizer control system on the car identifies and authorizes remote control keys to normally use the car.

RESETINJEC - The software is use for Injector coding. Write injector actual code or rewrite code in the ECU to the injector code of the corresponding cylinder so as to more accurately control or correct cylinder injection quantity.

ODOMETER - The software is use for oil reset. If the service lamp is on, you must provide service for the car. After service, you need to reset the driving mileage or driving time so that the service lamp turns off and the system enables the new service cycle.

RESETBMS - The software is use for Battery Registration reset. Use the car diagnostic device to reset the car battery monitoting unit to clear original fault information about insufficient battery electric quantity, and match the battery again and monitor battery based on current battery information.

RESETBRAKE - The software is use for brake reset. If the brake pad wears the brake pad sense line, the brake pad sense line sends a signal sense line to the on-board computer to replace the brake pad. After replacing the brake pad, you must reset the brake pad. Otherwise, the car alarms.

RESETETS - The software is use for Electronic throttle sensor reset.Use the car decoder to initialize the throttle actuation element so that the ECU learning value is returned to the initial status to more accurately regulate throttle (or idle motor) operations to control intake air quantity.

ODOMETER - The software is use for Odometer calibration. The instrument mileage adjustment is to copy, write or rewrite the kilometers. Usually, the mileage adjustment should be done if the speed sensor is damaged, the instrument fault leads to the incorrect mileage, after the maintenance completed.